Tired of dealing with high-maintenance water heaters? Say goodbye to bulky tanks and hello to hassle-free hot water with a tankless water heater. In our guide, we'll show you how to quickly maintain your tankless water heater, ensuring it runs smoothly and saving you money.
From cleaning the water filter to flushing the system, Adair Plumbing will guide you through step-by-step maintenance tips.
Don't let repairs drain your wallet; keep reading to learn how to enjoy continuous hot water quickly.
Cleaning the Water Filter
To keep your Gilbert, AZ tankless water heaters operating at its best, regularly clean the water filter. This step is crucial to maintaining the efficiency and longevity of your system. Follow these simple steps to clean your water filter:
Turn off the power to the water heater. This ensures your safety during the cleaning process.
Locate the water filter. It's usually located near the cold water inlet pipe. You may need to consult the installation manual for precise instructions.
Remove the filter housing by unscrewing it. Be careful not to damage any components.
Take out the filter and rinse it under running water. Use a soft brush to gently scrub away any debris or sediment.
Inspect the filter for signs of damage or wear. Replace it with a new one.
Reassemble the filter housing and tighten it securely.
By regularly cleaning the water filter of tankless water heaters Gilbert, AZ, you ensure optimal performance and extend its lifespan.
Contact a professional tankless water heater installer or water conditioning installation expert if you need help or have questions.
Flushing the Heating System
To properly maintain your tankless water heater and ensure its optimal performance, it's important to regularly flush the heating system. Flushing the heating system helps remove any mineral deposits or sediment that may accumulate over time, which causes reduced efficiency and potential damage to the unit.
Here is a step-by-step guide to flushing your tankless water heater's heating system:
- Turn off the power supply to the water heater.
- Locate the cold water isolation valve and turn it off.
- Attach a hose to the hot water isolation valve.
- Open the pressure relief valve to release any remaining pressure in the system.
- Connect the other end of the hose to a drain or bucket.
- Open the hot water isolation valve and let the water flow through the system, flushing out any debris.
- Allow the water to flow for about 10–15 minutes or until it runs clear.
- Close the hot water isolation valve and remove the hose.
- Close the pressure relief valve and open the cold water isolation valve.
- Turn on the power supply to the water heater.
Adair Plumbing for Water Heater Services
Last but not least, maintaining tankless water heaters Gilbert, AZ is crucial for its longevity and optimal performance. By regularly cleaning the water filter and flushing the heating system, you can avoid costly repairs and enjoy a continuous hot water supply.
Did you know that tankless water heaters can last up to 20 years, while traditional water heaters typically last 10–15 years? Taking proper care of your tankless water heater will ensure it serves you well for many years to come.
Always remember that Adair Plumbing is your reliable partner in plumbing. Contact Adair Plumbing today for the best plumbing services in town. Also, you can check out more on Angie's List here.